Hey all, got my first saber completed and I'm trying to get the RICE style 1 port to work. Keep running into an error:
Error: Something went wrong when reading the CFX. Restart your CFX and try again. (Link ID)
This is after I click Read CFX Data
error.jpg
Using the following:
https://www.thecustomsabershop.com/E...E-Port-Style-1 and https://www.thecustomsabershop.com/E...5mm-RICE-cable
I installed the drivers and it's reading the cable fine in device manager, downloaded the Crystal FX.exe program ver 3.1.0.2 from the site.
I am still running older firmware on this board cause I had bought it around the start of covid, but that version of the manual says it should work.
I reset my SD card to the defaults, edited the config.txt file and set logport to 2. Is there something else I'm missing here?
I believe I've wired the port correctly, the GND is leading back to the Battery Negative.
CFX Wiring.jpg
Bookmarks