Results 1 to 4 of 4

Thread: Need help with CFX!

  1. #1

    Default Need help with CFX!

    Hi folks, my board is wired for sound (and light, but not connected), when I apply the power (SD inserted) it lights up red for a few seconds then shuts off with no start up sound. Using the activation switch has no effect. When the SD card is not inserted, it just flashes. Does this mean I might have fried the board?

    Any help is appreciated!

  2. #2

    Default

    You might have a dead speaker, a disconnected wire, or a bridge in your speaker wiring. Would need good high quality close up pics of the wiring.
    TCSS MODERATOR
    All n00bs READ these first (PLEASE)!!!:
    1. Forum Guidelines
    2. FJK’s “Down and Dirty” guide to Ohm’s Law

    "Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
    My email: fjk_tcss@yahoo.com

  3. #3

    Default

    I sent photos, the board is not connecting to the crystal fx desktop app either

  4. #4

    Default

    You were right, speaker wire connection was bad, however it went into deep sleep mode

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •