Cool! Power Level Indicators!

[Lord Maul]

i'm pretty sure. corbin could probably confirm this

[Firebird21]

I'd just get another Y-Splitter and plug it in... lol


I think it's supposed to be wired in Parallel with and before the Sound Board (if so equipped).

[Tenric Starkindler]

IF I understand correctly ..............body edited for stupidity's sake (Mine )

[Jedi Ranger]

No! Put it AFTER the switch, or it will always be on. Did you look at LM's simple diagram?!

[Tenric Starkindler]

No! Put it AFTER the switch, or it will always be on. Did you look at LM's simple diagram?!

no I didn't really. Thanks. it does make sense AFTER the switch, probably what I meant to say...its been one of those days.
weeks actually.........

[Lord Maul]

tenric, why didn't ya?
i put it there for a reason. lol

[Tenric Starkindler]

simple assumption problem........looked like what I had seen before.
then I forgot the whole issue of why a switch was there......just had a "blonde" moment...forgive me

[Hasid Lafre]

So one wire on a switch wire and the other on the pos side of the batery pack?

[Jedibum]

Hi guys! Sorry to bump an old thread, but I was wondering if I could get a definitive answer about the best way to wire Corbin's PLI to a saber using a sound card (MR sound card or Ultra). I purchased one and want to get more for my other sabers but I want to make sure I wire this thing correctly. I assume you already use the wires provided, should I cut off the connector? Anyway, any help would be great! Thanks guys!

[xwingband]

Unless you are using the J-plugs just cut it off.

PLI's are dead simple. Just put each of the wires to the respective battery leads... then interrupt the loop with a momentary switch (or latching if you prefer).