Results 1 to 6 of 6

Thread: Why Solder to Top of Pad Rather Than Inserting Wire Through the Pad Hole?

  1. #1

    Default Why Solder to Top of Pad Rather Than Inserting Wire Through the Pad Hole?

    Hello from smoky Seattle.

    Student question that I can't answer:
    why solder wires to the top of a pad rather than inserting the wire end into the pad hole and soldering like that?
    To save space above the pad?

    Thanks again for the wisdom!

  2. #2
    Sith Warrior darth_chasm's Avatar
    Join Date
    May 2015
    Location
    United States
    Posts
    1,747
    Blog Entries
    2

    Default

    Maintenance on Through hole is a bit harder and requires a braid or pump to remove solder. Top solder is easier because you just heat it up and slide it off.

    however, top solder introduces risk of tear pads off the pcb. Through hole typically does not.

    both have pros and cons.
    末末末末末末末末末末末末末末末末末末末末末末末末末 末末末末

  3. #3

    Default

    Good question! And there are multiple reasons,
    1) it allows to save space above the wire
    2) it allows you to solder the wire in the direction that the wire is running(less stress on it)
    3) it allows for a stronger solder joint because there is more wire being soldered to the pad, which in turns makes it more resistant to bending and jostling around

  4. #4

    Default

    Soldering through makes it easier to solder to both sides since the wire is less likely to ping off, although one side would usually be surface.

  5. #5

    Default

    Surface soldering allows you to easily repair a joint if necessary. Also, it allows you to lay you wiring flat a d if you plan it properly, makes running wires easier with less stress on the wire (as was previously mentioned). Also, trying to clean up a through hole solder joint is NOT a fun experience especially if there are stands of wire still in there.
    TCSS MODERATOR
    All n00bs READ these first (PLEASE)!!!:
    1. Forum Guidelines
    2. FJK痴 泥own and Dirty guide to Ohm痴 Law

    "Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
    My email: fjk_tcss@yahoo.com

  6. #6

    Default

    Thanks for the wisdom!
    It all makes sense, especially the part about repairing mistakes.

    Not that we make mistakes in the classroom, of course.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •