Results 1 to 3 of 3

Thread: My new Jedi shoto on a budget

  1. #1

    Default My new Jedi shoto on a budget

    Hi @all

    After 4 years without lightsaber building I have decided to give one of the really cheap China sabers a try.
    Overall I am very happy with this buy. The ice blue colour of the blade is very bright. The 3 sound fonts are also really good.
    I can choose 3 volume levels plus mute. It has flash on clash , lockup loop and several light effects :
    full bright mode, mid and low brightness , breathing mode, heartbeat mode, flickering mode
    Blade diameter is 22,2 mm with a length of 78 cm. The hilt length is 29 cm.
    I've attached some details (O-Ring seals, picture hook and electrical tape) and did a weathering to the hilt.
    The flame at the top of the hilt was done by salt-etching and the scratches with a Dremel tool.
    The pommel was made using a Neoperl faucet sprayer bought from Bauhaus DIY Shop in Germany.

    Cheers yogie

    5.jpg1.jpg4.jpg3.jpg
    Last edited by Yogie; 07-26-2020 at 01:21 PM.

  2. #2

  3. #3

    Default

    Done.
    I've added some details to the hilt.
    A nice pipe clamp I've found in our hardware store to break up the slim design of the hilt.
    And some shims to build a little Tsuba

    10.jpg
    Attached Images Attached Images
    • File Type: jpg 6.jpg (91.2 KB, 19 views)
    • File Type: jpg 7.jpg (71.3 KB, 14 views)
    • File Type: jpg 8.jpg (87.4 KB, 16 views)
    • File Type: jpg 9.jpg (93.4 KB, 16 views)
    Last edited by Yogie; 08-02-2020 at 05:03 AM.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •