Page 2 of 2 FirstFirst 1 2
Results 11 to 12 of 12

Thread: Neopixel blade not lighting up

  1. #11

    Default

    Ok so to update on the situation, I left it for a month to get away from it and think then went back to it.

    I got a new hilt side adaptor, re did all the wiring, and nothing, lights still don't work, which leaves the worry that something is wrong on the board. Any ideas on what I could do?

    I was thinking of ordering another blade to see if by some off chance it's the blade

    I've also made the hilt longer, as I realised it was too short

  2. #12

    Default

    Try taking it out of the saber, make direct connections and minimal components. Any pixels will be fine to test, it doesn't need to be the blade.

    Wire the blade power directly to the battery, this will bypass any hardware or configuration issues as far as that goes.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •