Results 1 to 3 of 3

Thread: Tier 2 Electronics Kit Card Configuration

  1. #1

    Default Tier 2 Electronics Kit Card Configuration

    I should be receiving my Tier 2 Electronics Kit today, and I was wondering what all I need to do before I try to turn it on. The store page says I need to configure the card that comes with it before I use it, but I was wondering if that is required if I initially want to try it out with the light/grey/dark meat fonts that come pre-installed. I've read the users manual, but it reads like you are installing new fonts right off the bat. I guess a simplified version of what I'm trying to ask is is the kit ready to use out of the box, and if not, what do I need to do to make it ready?

  2. #2

    Default

    By configured it probably means that the SD card either comes blank or only has the default starter profiles/fonts that come with the NB. if it's blank you can get the default package from the plecter labs website in a download and use that as your base. If it's got the defaults then by configure I can only think it means making sure the profiles are set up correctly to not send too much current to your Tri-cree dies.

  3. #3

    Default

    Te cars comes with fonts and a standard configuration. Depending on where int he hilt you install the card will depend on how well the cars will work/respond. You can tune it from there.
    TCSS MODERATOR
    All n00bs READ these first (PLEASE)!!!:
    1. Forum Guidelines
    2. FJK’s “Down and Dirty” guide to Ohm’s Law

    "Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
    My email: fjk_tcss@yahoo.com

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •