Hello all
This is my first build so I have done a bunch of reading and have checked my work over multiple times. After I wired up the sound board it was time to test the SK6812 rgb strips. I tested each one separately and they worked great in all three fonts. I hooked them up together and got a few pixels on one strip working and now they both show no light at all. I am using a Spark3 sound board, Keep Power 15 amp high drain battery, 22 gauge wiring for everything except the speaker. I am also using 330 ohm resistor on the data line. The battery was freshly charged and is reading over 4 volts. I have read many posts in the string blade section but cannot find any answers to my dilemma. Anyone have some ideas on what to check?