How does this parts list look for a neopixel/profie/luke ESB/Graflexshop replica?

Graflex 1.9 non blem with stamped bottom and side
Deluxe Top Lip Blade Adapter (1 inch bore)
6 Piece notched rubber grip set 3.6"
ESB Grip Guide
Kobold Clip with D-ring ESB
Edge Connector (gold plated) ESB
GOTH-3D Vintage Graflex Chassis Variant 2 FDM ECO Chassis
1″ OD Trans White WS2812 NeoPixel LED Strip Blade With KR Connector (MagConnect Ready)
KR NeoPixel LED Strip PCB Holder – Hilt Side – 1″
KR NeoPixel LED Strip Rotary PCB Hilt Side Kit
470ohm Carbon Film Resistor
390ohm 1/4w resistor
Keeppower 3.7v 3120mah 15A High Drain PCB Protected Removable Lithium Ion Battery
Keystone 18650 Battery Holder – For Button Top 18650 Battery
ProffieBoard v1.5 – Open Source Sound Board + 16GB Micro SD
High Amp Kill Switch
2W 28mm 4ohm OD Bass Speaker – Black Edition
Graflex Blade Holder Slider Switch
Low Profile Red Tactile Switch (2.5mm Height)
Removable Dual Battery Smart Charger
4-40 rods (qty=2)
4-40 nuts (qty=2)
20 awg PTFE wiring, assorted colors 50 ft
30 awg PTFE wiring, assorted colors 50 ft
28 awg wiring, spool black 25ft
Switchcraft 2.1mm Power Jack
E6000 231020 Adhesive with Precision Tips, 1.0 fl oz
560PCS Heat Shrink Tubing set down to 32 awg
3M tape double sized 1.5 thick
Testors paint

Spent about $550 on all the above

I may do a goth 3Designs Master chassis with crystal chamber in the future at some point, but some of these custom CC builds I've been seeing make me want to go that route instead and just do a more custom chassis.

Here's my tools list. Some new, some I already have. Spent about $150 on what I needed

Eclipse Tools CP-301G Pro'sKit Precision Wire Stripper, 30-20 AWG
X-Tronic Model #3020-XTS Soldering set
Vermont American 21916 T-Handle Tap Wrench 0 through 1/4 Inch
IRWIN HANSON 4 - 40 NC Tap and No. 43 Drill Bit Set, 80209
Battery Holder Case Box with 3" Wire Leads
5 Pieces Micro Toothless Alligator Test Clip Copper Plated Electrical Connectors
Helping hands
Tube cutter
Digital micrometer
Drill
Heat gun

I've watched all the TCSS vids, East Coast Sabers vids, read the proffie manual below and reviewed the wiring diagrams.

https://thesaberarmory.com/wp-conten...ual_v1.5_6.pdf
https://fredrik.hubbe.net/lightsaber/v4/
https://wannawanga.com/wp-content/up...aber_Guide.pdf

Everything seems pretty straightforward. What's everyone using for wall chargers that plug into the 2.1mm port?