Hey all.

Been watching various forum posts for a while.
Still stumbling around trying to figure things out.

I have begun to complete what parts I am confident enough with such as the PCB connector and pins, speaker and power connections. So in the middle of the build until I get some help to complete the parts I am stuck on. I really want to avoid doing permanent damaging anything.

I have a few questions if I may.

1. Can I get away with keeping the same latching switch in the clamp to ignite my lightsaber? Looking to hide a 6mm tactile momentary inside the bulb release for my AUX with a bit of modification work to the hilt and TCSS conversion kit blade holder?

2. Do I connect the Two negatives and positives from the PCB connector to the L2 and L1 only and ignore the L3?

I appreciate any help. I even bought a soldering iron and Dremel for this project so anxious to get it done and impress my nieces and nephews who I have slowly been turning to the darkside....lol

Thank you in advance,

Steven