Results 1 to 3 of 3

Thread: New Build w/ Nano Biscotte V4 Assembly

  1. #1

    Default New Build w/ Nano Biscotte V4 Assembly

    New to TCSS and this is my first build. I received my hilt parts, and electronics. NB V4 assembly (https://www.thecustomsabershop.com/M...bly-P1445.aspx), BuckPuck 1000mA 4-wire, SPST Momentary Switch, and Rebel Star LED & MHSV1 Heatsink (https://www.thecustomsabershop.com/R...dule-P653.aspx).

    No wiring diagram came with the NB Assembly. I have no idea how to wire the switch, buckpuck,and LED. I presume these are in series, but the wiring makes no sense with the way the connectors are set up. The BuckPuck has 4 wires: LED + (white) and LED - (blue).Then VIN + (red) and VIN - (black). I assume VIN = voltage in. So the + (White) from the NB wiring harness goes to BuckPuck VIN +, and the - (yellow) from the NB wiring harness goes to BuckPuck VIN -.

    Then the output LED goes to the corresponding sides of the LED/HeatSink.

    Where does the switch plug in? (Update) I came across another post that mentioned that a momentary switch doesn't work with the BuckPuck. I also happen to have a latching switch I purchased (16mm anti-vandal latching blue ring switch). This one has five connectors (+ and - then N01 NG (?) and C1). So this adds some additional complexity to my build.

    Any help would be greatly appreciated!
    Last edited by sdsguru; 04-23-2019 at 08:39 PM.

  2. #2

    Default

    Did you see this on the store site
    The pinout is different..

    From top to bottom, board pinout
    ** Positive (+)
    ** Negative (-)
    ** Activator switch
    ** Channel 1 (-)
    ** Channel 2 (-)
    ** Channel 3 (-)
    ** NeoPixel Data
    Donít work with buckpuck so canít help there

  3. #3

    Default

    You can't use a BuckPuck with the Nano Biscotte. The voltage requirements for each are incompatible with the other.

    https://www.thecustomsabershop.com/1...ver-P1211.aspx would work, as would using a resistor.

    https://www.thecustomsabershop.com/N...ess-P1144.aspx has details on hooking up to the wiring harness on the NB.
    Last edited by Silver Serpent; 04-30-2019 at 08:42 AM.
    We all have to start somewhere. The journey is all the more impressive by our humble beginnings.

    http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
    http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •