New Build w/ Nano Biscotte V4 Assembly

[sdsguru]

New to TCSS and this is my first build. I received my hilt parts, and electronics. NB V4 assembly (https://www.thecustomsabershop.com/M...bly-P1445.aspx), BuckPuck 1000mA 4-wire, SPST Momentary Switch, and Rebel Star LED & MHSV1 Heatsink (https://www.thecustomsabershop.com/R...dule-P653.aspx).

No wiring diagram came with the NB Assembly. I have no idea how to wire the switch, buckpuck,and LED. I presume these are in series, but the wiring makes no sense with the way the connectors are set up. The BuckPuck has 4 wires: LED + (white) and LED - (blue).Then VIN + (red) and VIN - (black). I assume VIN = voltage in. So the + (White) from the NB wiring harness goes to BuckPuck VIN +, and the - (yellow) from the NB wiring harness goes to BuckPuck VIN -.

Then the output LED goes to the corresponding sides of the LED/HeatSink.

Where does the switch plug in? (Update) I came across another post that mentioned that a momentary switch doesn't work with the BuckPuck. I also happen to have a latching switch I purchased (16mm anti-vandal latching blue ring switch). This one has five connectors (+ and - then N01 NG (?) and C1). So this adds some additional complexity to my build.

Any help would be greatly appreciated!