Results 1 to 2 of 2

Thread: Shroud and powder coating

  1. #1

    Default Shroud and powder coating

    I have all my parts to a double bladed saber I'm building and got them all powder coated, but I have gotten to the point where I was going to put the shroud on and it barely fits. Does anyone have any suggestions to how I can fix this or is it a lost cause. The colors are transparent Copper and olive green.

  2. #2

    Default

    It's not a lost cause, but you're in for a bit of work. Do a Google search for a "cylinder hone" and you'll find a tool that can help you increase the inner diameter of your shroud. I've had to do this before to help get a shroud on over a paint job.

    You'll need the hone, a drill, and a good bit of time.

    For future builds, you can ask TCSS to turn down the parts a bit before they're powder coated. That way the shroud will fit over it properly. Good luck!
    We all have to start somewhere. The journey is all the more impressive by our humble beginnings.

    http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
    http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •