Hello! Ok, I think I’ve got everything for my first full build, so far all I’ve done saber wise is replace a speaker. As such I’d love if people would give my parts list a once over and tell me if I’ve forgotten anything for my proffieboard neopixel build.

First: The non-TCSS parts
-Proffieboard
-3D printed MSHV2 chassis. Meant for Prizm, but should be golden
-26 AWG wire

Then the TCSS stuff:
-MHSV2 hilt components (pommel, insert, o ring, extension, double male adapter, choke, extension, blade holder)
-Millwork for two 12mm AV switches, 2 blade holder set screws
-set screws
-3W 20mm speaker
-Switchcraft 2.1mm power Jack (internal install)
-3.7-14.8v smart charger with plug adapter
-18650 3.7v 3400mAh battery
-12mm blue ring switch
-12mm red ring switch
-20mA DynaOhm variable resistor x2 for switches
-1” Neopixel hilt side adapter V2
-Pre-soldered Neopixel PCB connector and 11 pin set
-1” thick walled Neopixel blade adapter
-330 Ohm SMD 0630 resistor for Neopixel connector
-SK6812 144 LED strip x2
-foam tube for 1” thick tubes V2
-1” thick walled trans white polyc tube

And finally, parts that weren’t in stock I’ll have to get before using the saber:
-1” thick wall Neopixel blade tip.

That’s a lot, but does it look like I’m missing anything? Any input is appreciated!

Thank you!