Page 3 of 3 FirstFirst 1 2 3
Results 21 to 23 of 23

Thread: NBv4 - No Flash on Clash

  1. #21


    And so one of those joints would be causing the lack of swing and clash? I've done a few of these boards and this is the first time this has happened.

  2. #22


    I'm seeing a couple of cold solder joints and a wandering strand of wire on the speaker connection. The solder point for the L3 wire looks to be shorting out to the small pad just above it in your picture. The L3 pad would be the first thing I'd look at. Just my two cents, hope you work it out.

  3. #23


    After a few more trials - I found the problem was with a nearly visible piece of solder on the only pad I didn't photograph (the one on the center of the board. Thanks for everyone's help!


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts