-
LED wiring issue
I can get my Tri-Cree RGD to illuminate when applying power to any/all of the dies with the optic assembly out of the hilt, but when I've wired up the entire system I'm only getting a quiet sound from the soundboard and no LED illumination.
Tri-Cree RGB led in MHS V4 flat heat sink, appropriately resistored
Pico Crumble Dark
illuminated momentary switch, appropriately resistored
3w 22mm speaker
3.7V 18650 li-ion cell
This is in a US dark prophecy v3 hilt
Is it possible that I'm shorting out through the LED -> heat sink module -> metal hilt? Is this a problem other people have had? I've tried using a cut piece of T8 tubing to try and insulate, but that didn't solve the problem and I'm not sure I was able to completely isolate the heat sink module from the hilt.
Thanks for your help!
-
Pictures would help.
First thing is to check you have a full charge on your battery. Next is just to go through each wire joint and carefully inspect your solder joints to make sure you have no strays, a single strand off one of your wires could be the culprit. The biggest thing I do is test, as I go along, usually after every single solder joint. It's a little bit of a pain, but I'm able to find any mistakes pretty easily that way.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks