Nano_v4 - Wiring Diagram.jpg
Working on my first install. Put this together based on a lot of research and wonderful YouTube tutorials.
Nano_v4 - Wiring Diagram.jpg
Working on my first install. Put this together based on a lot of research and wonderful YouTube tutorials.
The one .5 ohm resistor is split to your to main color LEDs. It will have half its value to each LED. Which will work for blues/greens. This wiring diagram looks fine, other than that.
There is another way, you can bridge all the positives on the LED Star, then just run one positive lead from the star to the board. Then you can put your resistors in the negative leads from the LED star. There are many ways to skin a cat.
Tom
"Mistakes are our greatest teacher."
Hello,
Thank you for the feedback. I am following this video which shows this version of wiring the Blue LEDs to one resistor at the 7:35 minute mark:
https://www.youtube.com/watch?v=v7BdiKfMkro
TCSS MODERATOR
All n00bs READ these first (PLEASE)!!!:
1. Forum Guidelines
2. FJK’s “Down and Dirty” guide to Ohm’s Law
"Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
My email: fjk_tcss@yahoo.com
Updated Diagram:
Nano_v4 - Wiring Diagram.jpg
Bookmarks