(edit to clarify wiring on L1)

Hello,

I'm having a bit of trouble with my NBv4 (pre-wired harness) with regard to FoC. I get the sound for FoC, but no flash.

I've got the red LEDs of the Cree XP-E2 wired to L1 and they work fine. I've got the white wired to L2, but it will not flash. I've tried so many combinations of setting fdrive and focmix values but nothing seems to work. I've independently tested that the connections on my LED (and attached resistor) are good through an adjustable, independent power supply. The clash sound plays just fine too.

I've read the manual, watched a number of YouTube videos on installs, and red posts in these forums, but the dots still haven't connected for me. I suspect something is wrong with my configuration files more so than the hardware, but if someone else might have a better way for me to confirm that L2 is doing what it should and/or that I've got a solid connection for the L2 harness, I would appreciate it. I should expect only the resistance of the LED if I hooked up my multimeter to L2 and power, right? I feel as though I must be missing something fundamental.

Thank you for the help!

Attaching my config files for reference

config.txt:


//Nano Biscotte 4.0
drive=1023,0,0
fdrive=1023,0,0
focmix=001
resume=0
shmrd=210
shmrp=6
shmrr=13
shmr%=0,50
focd=200
focp=10
focr=10
foc%=0,80
qon=0
qoff=0
flks=13
flkd=50
pulsed=0
pulsel=0
lsfadeon=0
lsfadeoff=0
lightstick=0
omnisabers=0


override.txt:

## Override File
vol=4
beep=40
rebootd=1250
motg=500
muteoff=0
gate=70
hclash=700
hswing=220
offd=200
swing=200
clash=150
deep=15000
ledstrip=0
ls0=14
ls1=28


Teaser pic:

IMG_7049.jpg