Originally Posted by
Tom Tilmon
That heatsink threads into the MHS LED Module, its fine. You didn't get a blade tip to go with your blade. You also need a MPS Pommel Insert and C Clip. You have wires already? How are you going to solder a harness on LED? I see you are using a power extender, so I assume this is RGB? If so, you need resistor for at least the red diode, but all 3 would be better off with them. Did you order hole drilling service in your hilt for 16mm switch? If you don't have a drill and tapset, you may want to order a 8-32 retention screw hole to be drilled in your blade holder to hold your blade in. You can pick up lots of little 8-32 retention screws at hardware stores or at TCSS.
Tom
Bookmarks