Results 1 to 2 of 2

Thread: Wiring for 20 mm speaker

  1. #1

    Default Wiring for 20 mm speaker

    Hi, simple question.

    The 20 mm speaker appears to have a total of 4 pads where a wire would be soldered down. This is my first 20 mm speaker, and I can't seem to find any info regarding whether only a total of 2 or 4 wires are needed. I figure if there are a total of 4 then each side would then be wired in parallel, then soldered down to the circuit board. Any information is appreciated, thanks.

  2. #2


    Two wires are all you need. Solder to one tab on each side.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts