Results 1 to 3 of 3

Thread: Neopixel strim Foam Diffuser

  1. #1

    Default Neopixel strim Foam Diffuser

    Hi everyone,

    i'm working on a 7/8 neopixel blade and was wondering if anyone had any tricks to getting the foam diffuser up in the blade. I can get it about halfway and then it just starts getting stuck.

    Thanks

  2. #2

    Default

    You could try pinching the section you are about to put in, then twist and push slightly.

  3. #3

    Default

    Tie a string to the end and pull it through.. unless you've already got the tip glued in

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •