Not at this time, but I’m going to post a build thread on it soon, I hope. Still working on what I actually want to DO to the thing!
Not at this time, but I’m going to post a build thread on it soon, I hope. Still working on what I actually want to DO to the thing!
TzW5uo.jpg
Used a Coupling section to sit under the clamp and drilled a path for the wiring. Used a 3d printed switch holder from Shtok (used a different one at first but didn't work well at all) as well as the Slothfurnace card which required a bit of sanding for the switch.
Thanks! Figured you were looking for something along those lines with the clamp card. One the card you'll have to sand underneath on the end with the switch (or both if 2 two switches are used). It's gonna be a trial and repeat process. IF you sand a bit too much you can apply tape or I've seen strips from aluminum cans used to fill back in. All depends on the switch and switch holder used.
A question Warlock, how well would that card light up?
Fairly well actually. Thou it will depend on LED power and location obviously.
Bookmarks