Page 2 of 2 FirstFirst 1 2
Results 11 to 13 of 13

Thread: First Official Saber Build Ideas!

  1. #11

    Default

    If you are using a MHS main body + and MHS Extension, how will you even see the rotating chamber?

    I’ve bench tested small RadioShack rumble motors, and to slow it down, I added more resistance to the circuit. Just wired in more resistors till there wasn’t enough juice left to let it spin.

    You may be over complicating things with a PWM & a POT.

  2. #12

    Default

    Depending on the motor it might not be possible to slow it down enough with just resistors, but I would certainly use that over the pot. Use the POT on the bench then read the value to get your resistor. If space is an issue certainly it makes sense to avoid cramming all of that in there.

  3. #13

    Default

    It is very carefully planned out with some custom made chassis disk. It's not going to be a large chamber. Only half an inch total length.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •