-
Using the NBv4 drive and fdrive as a configurable resistor
Hi All,
Page 13 of the NBv4 manual talks about using the drive and fdrive parameters as a configurable resistor for resistor values smaller than 0.5ohms. I wanted to know if anyone here has done this and how it has worked out. I currently plan to use this setting for the Royal Blue die of my Tricree RGRyB LED. If I am reading the manual right I should be good as long a I don't try to set the following colors because it would put the setting too low to work as a resistor.
Cyan R-0 G-1023 B-340
Light Blue R-0 G-1023 B-635
Crimson R-1023 G-0 B-50
Any details you can provide on your experience using this setup will be greatly appreciated.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks