they're expoxied on. try to gently pry and break each of the windings free from the back side of the plate, then tap the shaft out of the bearing. I have successfully freed a few of these. I used a very small flat head screwdriver to pry it off.
Tom
"Mistakes are our greatest teacher."
I tried to tap out the shaft with a hammer but it didn't come out yet. What should I do?
[QUOTE=Tom Tilmon;274506]they're expoxied on. try to gently pry and break each of the windings free from the back side of the plate, then tap the shaft out of the bearing. I have successfully freed a few of these. I used a very small flat head screwdriver to pry it off.
If it is epoxy... try heating the back with a flame from a lighter for a bit then pry gently from different sides. I have taken some of these off like that.
Pop the center out and then come in from the backside with a step drill on a press, youll know when its free. Thats the easiest way, prying will just snap the plastic on the stator.
Bookmarks