Recessing a non-recessed switch hole.....advice needed

[Darth_Banyon]

I have a hilt with a hole drilled for a 16mm switch but not recessed I want to use an illuminated momentary AV switch I can use a bezel but that raises the switch up just enough that I cant get the nut to thread onto the switch so I would need to glue it in (would prefer to avoid that) and as it is going to be the saber I duel with in The Saber Legion I would like the switch to be as low profile as possible so as to not disrupt my grip during sparing....

Is there a way i can cut the recess into the hilt? a forstner bit perhapse?

any recommendations would be greatly appriciated.....




n