Hey everyone! I finally finished wiring my first nano biscotti! I remove the kill key the first time and that boot up is SO LOUD. I love it!

Problem is, I'm color mixing cree red and green for a yellow, and the transwhite thickwall blade I'm using actually looks half red and half green with a yellow foot at the end. Que the rots Vader NOOOoooOooOoOOOooo!!!

Nano biscotti v4
18650 rechargeable 3.7 li-ion from the shop
Tri cree red green white(unused till I get a color extender)
.47ohm .5 watt on green
1.8ohm 2 watt on red

I tried to take a picture of the blade, but photos come out white. Also, my yellow dot av switch looks more like green. I have the dynaohm resister on it's mainline, and it's negative is hooked up to my blade, on pad 1.

I'm going to buy some cellophane wrap for the blade and try that out, and I'm charging my battery as I type hoping that's the issue with my switch led.

Wisdom is always appreciated! Mtfbwy!