-
12v AV Switch question
Can I wire up a 12v AV switch to the power indicator on a NBV3?
I've bought some for some builds intending to do just that but I don't think they will light up, will they?
Thanks.
-
Council Member
Jedi Council Member
I have a few of those myself, and no they do not light up very well on a 3.7v set up.
-
So I would need to run them in parallel with the main LED but lose the power on indicator functionality yeah?
-
Council Member
Jedi Council Member
It may work a bit better, but they still won't light up properly on less than the rated 12 volts. They have an internal resistor that can be removed if you aren't afraid to try an take one apart. You might be better off getting one that is rated for 3.3v for the led instead.
-
I've taken some switches apart and replaced the LEDs with 5mm RGB. It's not that hard for the 12mm momentary switches, which are mechanically very simple. I remove the lamp all together and drill a 5mm hole in the back. I believe I posted it about it some time last year.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks