Prizm 5.1 neopixel help.

[0XxZachAttackxX0]

Hello there!

So I am trying to finish my saber, and I cannot get it to work.

-2x WS2812B neopixel strips
-1x 18650 battery (Since I am not using a charge port, I am going upgrade to a high drain battery)
-1x 2w speaker 8 ohm
-2x SPST Momentary tactile switch
-1x PRIZM 5.1
-1x 4.7k resistor (This is going to be changed to a 470 ohm resistor)

-I wired everything up, checked the connections, added my resistor, popped in the battery, then the SD card, pressed the buttons, and nothing happened. I figured it was either the way I wired my switches, or maybe the SD card is not configured correctly. I don't understand why I'm not at least getting sound. I plugged the blade in after to see if it would activate, no dice there as well.

-When configuring the SD do I need to place the overide text folder into the profile folders? Or will it be set for all of the profiles? I was confused on this part while reading the instruction manual, and I couldn't find anything online about how to set this up. Is there a video on how to configure this without the RICE port?

Any ideas would be so appreciated I cannot wait for this to be completed!

Thank you!

I have attached a diagram of my wiring, and a picture of my wiring to the switches.

20171108_120148.jpg20171108_205320.jpg

[Silver Serpent]

Pop the battery on your charger for a few seconds. It may still be in shipping mode. They're typically shipped with the PCB tripped intentionally.

[0XxZachAttackxX0]

I actually pulled it off of the charger to test everything, so it was fully charged. Thank you!

[Zzan]

since you used an inline resistor on the data line did you bridge the SMD pad on the board? If not you have no connection From page 34 of the manual:
For space saving, we have included a 0603 resistor footprint just before the LS pad if
the user prefers to use a SMD resistor. If an external resistor is used, the pad can be
bridged and the resistor wired externally

[0XxZachAttackxX0]

since you used an inline resistor on the data line did you bridge the SMD pad on the board? If not you have no connection From page 34 of the manual:
For space saving, we have included a 0603 resistor footprint just before the LS pad if
the user prefers to use a SMD resistor. If an external resistor is used, the pad can be
bridged and the resistor wired externally

Yeah I bridged the LS pad. I got that information last night after I posted this, and bridged it.

Thank you!

[0XxZachAttackxX0]

Update:

I figured out the problem!

The battery holder I am using (http://www.thecustomsabershop.com/18...lder-P886.aspx) does not like to accept flat top 18650 batteries.

I solved this issue by building the positive post on the holder with a fair amount of solder.

Here is a picture of it in action!

https://imgur.com/VHXGk8E

So I have a question about the blade now. Is there a way to up the brightness of this? I can still see the LED's through the foam. I have not put it in the blade with the film yet. I was just curious of if there is a way to try to mask the LEDS a little better.

My plan is to put the LED's and the foam into the blade, add the TCSS film, and sand the blade a little bit.

Thoughts on this?

Again thank you to everyone who helped make this work!

I appreciate ya'll!