Parts List for a Build

[siucowboy]

Build List I'm working on. Have a variety of chassis parts selected as well - going to see if I can get the recharge port in the pommel while still having a chassis setup behind that (standoffs or a spacer in between)

Blade Trans White Battle blade 1" OD (30 inches)
Blade Holder MHSV1 Blade Holder Style 26
Choke MHS choke style 1 short
Hilt Hilt style 4
Pommel MPS Pommel style 3 v1
MPS Insert style 6
MPS Clip

LED Green/Green/White Cree XP-E2 CopperNova
MHS Heat Sink V3
18deg Tri-Rebel/Cree Star Lens
Star thermal tape pad - Tri LED
.5ohm 3w resistor resistor (for the white channel, the greens I believe I can limit with the drive parameter on the board....but I have enough resistors I could still put one on each of the greens too)


Power Source Panasonic Li-Ion 18650 3.7V 3400mAh PCB Protected Rechargeable Battery
Recharge Port 3.7V Li-ion smart charger with 2.1mm plug
Kill plug style 2
Switchcraft 2.1mm Power Jack

SoundBoard Nano Biscotte Sound Module V4
Speaker Premium 28mm Speaker

Switch 16mm Anti Vandal Momentary Green Dot/Ring Switch (will use a 20mA DynaOhm for this if I have the room)
Flat bezel for 16mm AV switches


Feedback is appreciated, thanks.