Hello Saber Enthusiasts! I came across this store on Etsy (TraywickDesigns) that offered 3-D printed hollow hilts. They only have three or four that are hollow but decided to give it a shot. I choose the Mara Jade Saber as I already have a Luke (ANH) saber. I left a list of Materials used as this was an easy stunt saber.


MATERIALS:

1.Tri Cree LED- RGRB-for a pink Saber
2. 3-D Printed Light Saber
3. 5 minute Epoxy Resin (Loctite)
4. Black and Silver Acrylic paint
5. 200 Grit Sandpaper
6. Dremel tool
7. Latching Switch
8. Brush
9. Hex screwdriver
10. 2 8-32 set screws
11. KR Sabers Perfect Purple Circuit Board
12. A couple of hours of your time


IMG_2695.jpg


IMG_2694.jpg


IMG_2693.jpg


IMG_2692.jpg


IMG_2691.jpg


IMG_2690.jpg


IMG_2685.jpg


IMG_2683.jpg


IMG_2682.jpg



IMG_2681.jpg


I hope y ou guys like this as this was a lot of fun to make!