I am wondering if my resistors are resisting too much. When I configure my blade for a White blade color (1023,1023,1023) it ends up being slightly pinkish. If I assume all my connections are good and correct then the only thing I can think that might be doing this is a lack of green and blue. I used a Tri-Cree RGB Led with a NBV4 with a PeX wired to a 3.7v battery. The red led has a 1ohm/2W resistor, the green has a .5ohm/3W, and the blue has a .5ohm/3W. I used 3W because that was the only .5ohm resistor I could get from TCSS. Are the resistors to much for the green and blue? I did the math and seemed ok, but maybe I'm overkilling? Thanks
IMG_E1035.jpg