I'm adding a 16 mm AV switch as part of my upgrade to my US Aeon V4, and I can't reach the nut to install tighten the switch. Any suggestions?
I'm adding a 16 mm AV switch as part of my upgrade to my US Aeon V4, and I can't reach the nut to install tighten the switch. Any suggestions?
Screwdriver, a long one. The nut should be on the wire and fall down to the switch. Use the screwdriver to spin the nut onto the switch. It'll work, just be patient. Sometimes this is a royal pain.
Tom
"Mistakes are our greatest teacher."
Depending on your setup, a short switch bezel on the inside might help you out... a lot.
TCSS MODERATOR
All n00bs READ these first (PLEASE)!!!:
1. Forum Guidelines
2. FJK’s “Down and Dirty” guide to Ohm’s Law
"Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
My email: fjk_tcss@yahoo.com
Bookmarks