With the release of the Prizm 5.1 We got a LOT of great changes. {All Hail Plecter Labs!}

However, in the manual there was no mention of a "Blade-On" pad for accents as it does for other boards. Instead, it got much more advanced with the addition of 4 Accent LED pads that can be programed with a sequence.

I was just wanting some clarification on the Accent Pads. If we use the Accent LED pads and set a sequence, does the stage/delay sequence start when the saber is booted and exits sleep/low power mode OR does the sequence start at blade activation?

Example: Accent LED Pad1) Iluminated A/V LED and Accent LED Pad2) Rumble motor with the following sequence. (Both with proper resistor)

s00=0011 < Stage 00 pads 1 & 2
d00=65535 < Delay set to Loop

Does Stage 0 (s00) begin at Boot/Wake or start at Blade ignition?

In short, I don't need a sequence or delay for this build because I don't have any blinking accents. I just want the Switch LED and the Motor to turn on when the blade is ignited.
If the Accent Pads sequence wont work as Blade-on, are there any recommendations of what pad to use?