L1 and L2 on bisquit should be bridged to negative on strip. L3 feeds the data line with 330-470 ohm resistor between board and strip. positive from battery or board is other remaining hook up on strip. I'll be using adafruit strips, and yes, they are expensive. For my Kylo, I'm looking at 180 bucks in strips. double sided full for main blade (2 strips) and an additional strip to build double sided quillions.
I'm not sure why yours is doing this, I hear the MOTG beep of the NBIV, did you change all your configs?
Tom
Bookmarks