-
-
For 45$? That's would be a steal even if it was empty hilt.
I have never seen an SMD blade like that.
Start with the NBV4 or another entry level board. It would be a waste of time to try and retro fit one like that.
Do you share your 3d hilt designs? I have a 3d printer and would like to collaborate with someone who is better at fusion360 than I (Only made simple chassis disks and crystal chambers).
You might be able to put a Hasbro "Econo" board in there for sound. Power up and down requires alot of electronic wizardry.
I would get you to message me , but you need 10 posts before that. I am also on fx-sabers and I am close to getting my teensy based saber working (sound in wrong format).
Take a pic of the battery pack if it os a rechargeable one, you might be able to use it again as well.
Good luck!
Last edited by Whosle; 07-09-2017 at 08:15 AM.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks