Hey, all! I'm working on my first saber, but I've studied others extensively and I think I'm almost ready to begin wiring things together. Here's my wiring diagram:
But before I start soldering, I have a few questions:
1. Am I understanding the buckpuck correctly? It sits in between the main LED and the NB, correct? I've seen elsewhere that I can just add a potentiometer to it to control the light intensity.
2. Is it possible to have accent LEDs (such as my switch light and crystal chamber) running from both the 3.3 V and Deep Sleep pads at the same time? If I have to choose one pad, can I still run the two LEDs? (Assuming it would have to be in series)
3. I bought a wiring harness with my NB v3 and it has a few extra wires (the white and yellow ones with the ? next to them in the image) attached to the LED positive and negative pads. Are those for main LEDs with multiple diodes? Since my main LED is a single, do I just leave those be?
Thanks for any advice. I like to think I'm a technical person, but my understanding of electricity is dubious at best. :P
Bookmarks