Hey guys, building the graflex 2.0 ESB kit. (Fantastic kit by the way. I'm super happy with it.)
I have a few questions:
When I'm screwing in the front "lens" it screws in part way and then stops. It seems like the threads aren't deeply cut and I just need to keep turning it and the screw will screw itself in. Is this the case?
For the red button on the top of the shroud immediately behind it, I notice the red insert buttons sit flush with the top. But that there are two switches attached to the circuit board. Is that what those are for? I see also that there are two button screw in knobs, one with the back, drilled away (for electronics?) and one without. So should I remove those physical switches from the printed circuit board, stick one in there and...glue it in? What's the procedure on that?
Bookmarks