Looking for some advice on a conversion.

I followed all of the steps in the appropriate saber conversion post and everything works, but my LED isn't lighting up. I rewired the LED and the wiring harness twice each to be sure I was getting it wired correctly. And I also tested the LED every step of the way prior to connecting it to the wiring harness and everything works, but once I hook it up to the harness and plug it in to the board, the LEDs don't light up anymore.

I'm wondering if anyone else has experienced this and/or if so, if a solution was found.

Sound and motion works great. Just the LED won't turn on.

The only difference on my conversion is that I'm using a 3-up Cree LED with 3 green dies. They have jumpers between 2 dies. So, I only soldered 1 positive and 1 negative wire, which I then soldered to the harness.

Anyway, thanks in advance.