Hey all. As suggested to me before, I wired the PLI in parallel to the board of my saber. However, it is now on all the time and will only show red light and some yellow if it's positioned just right. I also cannot actually turn on my saber now with it where it is. I've seen in the forums that you need a recharge port so it doesn't do that, but I don't want to put one on this saber. So my questions are these.
1: Do I need a new PLI (which aren't in stock right now)?
2: Where would I wire in the PLI if I don't want it on all the time with the ability to actually turn the saber on?
Thanks guys.
Bookmarks