Nano Biscotte v4 Manual Question

[hutch009]

Hello All

I was reading the manual for the Nano Biscotte V4 and on page 10(actually page 11 in the PDF) I notice some text that contradicts the image above it.

In the image all the resistors are connected to the negative pads on the LED and then connect to the L1, L2, L3, pads on the Sound Board.

However the text under the image says the following:
The positive of the LED goes to the power resistor and to the positive of the battery, the LED negative goes to the L1- and L2- pad of the board

Which is correct? The text or the image?

Thanks in Advance

[gerrylum]

Both. Pretty sure you can place the resistors on either the positive or the negative.

[Jay-gon Jinn]

I would go by the image, where your resistors are on the negatives, when color mixing different color leds, you'll want the resistance to be correct for the particular color you're running. Putting it on the positive which is shared by all three leds, you'll be "resistoring" all three at the same time.