Hey, I am attempting to wire up my first saber with a pre-wired nano biscotte v3
I have a few caveats though..... as I said I am using a pre-wired nano biscotte v3, and I want to use the pre-wire set. I also want to do this without a kill switch. I have been reading the basic schematics and it seems as if its an easy enough bypass, as I can just connect the battery direct as opposed to having the kill switch.
Yes I am aware of the power drain, however I am working with what I have, and I plan to have multiple batts for con-use anyways.
I have a tri led, 2 orange, 1 white, so I can use flash on clash.
A momentary activation switch
1x 0.5 ohm resistor, and 2x 1.2 ohm resistors
the 1.2s are for the orange leds while the single .5 is for the white
and a huge mess of color coded wires.
I am looking for pointers in regards to my current diagram I drew up. I am hoping for some assistance to fill in the gaps for the FOC effects
biscotte.jpg
Bookmarks