Results 1 to 3 of 3

Thread: Prizm 4.0 - Error switching fonts

  1. #1

    Default Prizm 4.0 - Error switching fonts

    Working with my first Prizm. I'm getting the following error when I try to switch fonts:



    Key points:

    Both switches are detected and configured
    Does this with both custom fonts and the stock card loadout
    Card was loaded properly (Full format, paste)
    Confirmed Plector fonts
    Full charge

    Fonts will eventually switch and work, but after 5-10 failed attempts. FB groups yielded no help sooo hoping someone on here can point me in the right direction.

  2. #2

    Default

    Defective SD card? If you have a spare, I would try that. Sometimes they go bad.
    We all have to start somewhere. The journey is all the more impressive by our humble beginnings.

    http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
    http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!

  3. #3

    Default

    Make sure your sd card is in all the way. I've seen that a couple times.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •