Results 1 to 2 of 2

Thread: First Install of NBV3 (noob) HELP!!!!

  1. #1

    Default First Install of NBV3 (noob) HELP!!!!

    wire nbv3 wiring FF.jpg


    HELP!!!

    LEDS
    the setup is running an tricree XP-E2 (B,G,W) each led have is the positive(+) pad an resistor (1ohm , 2w) that are connected to the battery power (+) and also to the Led Positive(+) pad of the NBV3, the negative pads(-) (G and B) are going to the led negative(-) pad of the NBV3, the W negative pad(-) to the FoC pad of the NBV3.

    BATTERY REMOVABLE and SWITCH
    the battery power negative (-) is going to the switch and to the negative(-) power pad of the NBV3. my setup is with an removable battery (3.7 18650 3.000 mAh Trustfire brand)

    Speakers
    going to the speakers pad of the NBV3.

    PROBLEM: when i turn on the switch it only runs the green led and it has phantom sounds. The FoC is running great. the blue led doesnt run. another thing, the resistor for the White Led that comes from the positive pad it burns like hell and sometimes i see some smoke from there.

  2. #2

    Default

    Your diagram looks fine. I'm thinking you may have some issues with your soldering work. If you could post pictures of your LED star and your NBv3, that would be very helpful.

    Smoke is NEVER a good thing to see when your saber is on.
    We all have to start somewhere. The journey is all the more impressive by our humble beginnings.

    http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
    http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •