Results 1 to 2 of 2

Thread: CF8 - Tangible Font Selection (TFS) - Connection

  1. #1

    Default [SOLVED] CF8 - Tangible Font Selection (TFS) - Connection

    Hello!

    I'm new to CF8 and I'm going to solder the resistor for TFS (tangible font selection) to the card... Actually, it's a simple push button to detect crystal presence, but for easier forum later search I used "resistor" term.

    I read a lot of docs and compared a lot of images to my card and I'm still not sure WHERE to place the device pins:
    - the first one is quite easy to find as a pad exists and is quite well identified in Erv's documentation;
    - the second one, is harder to me to find: depending on the image there is a resistor at the supposed location, sometimes not.

    Here is MY card. I placed markers to various locations I suppose I should solder the pin... Could an Expert confirm to me (and to others how are wandering) which one is the correct one?

    CF8-Top-TFS.jpg
    1. Obvious first pad
    2. Left pad of the resistor?
    3. Right pad of the resistor?
    4. Bottom-left pin of the component?

    Thanks for the help!

    Anorr
    Last edited by Anoril; 04-11-2017 at 01:06 PM.

  2. #2

    Default

    Hi there!

    Erv' replied to me: it's pad #3 on the picture.

    See U all

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •