Hello!
I'm new to CF8 and I'm going to solder the resistor for TFS (tangible font selection) to the card... Actually, it's a simple push button to detect crystal presence, but for easier forum later search I used "resistor" term.
I read a lot of docs and compared a lot of images to my card and I'm still not sure WHERE to place the device pins:
- the first one is quite easy to find as a pad exists and is quite well identified in Erv's documentation;
- the second one, is harder to me to find: depending on the image there is a resistor at the supposed location, sometimes not.
Here is MY card. I placed markers to various locations I suppose I should solder the pin... Could an Expert confirm to me (and to others how are wandering) which one is the correct one?
CF8-Top-TFS.jpg
1. Obvious first pad
2. Left pad of the resistor?
3. Right pad of the resistor?
4. Bottom-left pin of the component?
Thanks for the help!
Anorr
Bookmarks