-
Resistance Verification
Hey guys. Wiring up my first sabers in a while and wanted to double-check resistance values. Trying to get 2 of these done in the next week, if possible.
Pico Crumble
Luxeon Tri Rebel R-G-RB
3.7V 18650
According to the instructions from Erv, the test was done with no resistance on B or G dies and a 1.8ohm on R.
According to the Luxeon data sheet for Rebel LEDs, I arrived at the following using the online LED resistance calculator:
RB vf=3.51, 1A (max); 1ohm, 2W
G vf=3.51, 1A (max); 1ohm, 2W
R vf=2.6, 700mA (max); 1.8ohm, 2W
To complicate matters, I believe I have a 1ohm, 2w currently hooked up to the RB die, but when I fire it up (with a full battery), swing sounds play continuously until it is turned off, so I suspect my resistance may be to blame.
Thanks in advance,
Jason
Last edited by Master Raa-nek Tollen; 03-31-2017 at 09:58 AM.
-
Jedi Padawan
You are using one of the websites? You can use the .47 ohm .5w resistors for your blue and green. Your red value is good, if you can buy that one.
-
Thanks for the quick reply! This is the calculator I used when I wired up my Nano and it worked perfectly:
http://led.linear1.org/1led.wiz
If I cannot locate the 1.8ohm 2w resistor, can you suggest an alternative?
-
Jedi Padawan
You'll have to round up to the 2.2 ohm 5 W one in the store. http://www.thecustomsabershop.com/22...istor-P11.aspx Or if you have a local source, any 1.6 ohm or greater 2 watt resistor should be ok, and will be much smaller.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks