-
-
Council Member
Jedi Council Member
I suspect it is because you are sharing a single resistor for your green and blue...they should each have a .47ohm resistor, not one for both.
-
Reds sometimes are slightly stronger in a rgb white mix, if you had a config to adjust I'd say jut to turn it down but the pico can't do that. I us dR/G/rB setups to help avoid this, not only i the red truer, but it's slightly dimmer presence blends better into whites (also makes killer purples)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks