MPP 2.0 Revel WIP

[darth_chasm]

3D printed steel with plastic insulators for the speaker, board and battery and a plastic coupler for the core to hilt connection. Solid as a rock!

Just needs a couple more holes, some cleaning and then the install.

[Greenie]

I was checking this out on the IRA. Wondered when we'd see it here. That looks so slick, you know I'd polish it within an inch of its life haha
Awesome work DC.

[darth_chasm]

you know I'd polish it within an inch of its life haha

Thanks. I would have too if I had the equipment. But definitely wasn't about to do it by hand. The customer was warned and is fine with the texture though so that's good. We'll call it star wars damascus

[Noyl Wendor]

Nice work DC. I dig I'm looking at doing the same with mine. So yours is definitely inspiring.

[robsith]

Very nice work DC. I personally like that kind of rough texture look

[darth_chasm]

Thanks fellers.

more good stuff to come.

[darth_chasm]

All dressed up and nowhere to go. Lost my thermal tape

[eastern57]

I, too, have an MPP....

[Greenie]

IT'S ON!

[darth_chasm]

I, too, have an MPP....