Page 2 of 2 FirstFirst 1 2
Results 11 to 13 of 13

Thread: New Saber Hilt bilt from scratch

  1. #11

    Default

    Ingenious way to match the curve of the hilt.

  2. #12

    Default

    I added a second blade retention screw to tighten the blade...and finally got the electronics done. A simple circuit..3.7 volt 3400mah battery,0.33ohm 2watt resistor, momentary switch, royal blue Cree LED. IT is bright..put a plug in and almost fried my retinas..had to add some masking tape to the bottom of the plug so I could get a photo. I think the green Cree is slightly brighter.. nothing wrong with royal blue.IMG_1167.jpgIMG_1166.jpgIMG_1163.jpgIMG_1164.jpgIMG_1162.jpg

  3. #13

    Default

    Finished the emitter plug, the LED is too bright so I will have to block it a bit from the back. Nothing very original got the idea from some pics I saw. It is a hard drive motor armature and a rounded brass cylinder I made this morning.IMG_1172.jpgIMG_1173.jpg

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •